You are here: Testing IEDs > Testing Log Services > How to Test Log Services
Support Home
 

How to Test Log Services

The Log Services tool can test IED logs by querying the log from in different ways.

First, select the Log Services tool from the tool selection on the left.

Logs are tested one IED at a time by choosing an IED Connection in the upper left hand corner. Upon choosing an IED a connection will be established if one has not already been made.

After selecting an IED Connection choose a log in the device to query:

In this case BayController1CTRL/LLN0.Q has bee selected. Once selected a Reset Log is performed which goes and retrieves all available entries in the log. The left side shows the header information for each entry in the log. Selecting an entry shows the data contained in the log entry on the right.

To monitor the log for changes setup an Auto Refresh of the log by setting a time interval then pressing the Start Refreshing button.

Or a manual query can be done by EntryID or by time.

The log can be queried from an EntryID. The combo box will be filled in with the available entryID’s. Choose one and press Query. The Server should return all EntryID’s after the one choosen.

The other way to query the log is between 2 times. The 2 combo box’s After time and To Time will be filled in with the available times. Once either After Time is choose or After time and to Time are chosen the Query button will be enabled. The Server should return all times after After time or between After to to Time depending if you set the To Time combo box.

 

You are here: Testing IEDs > Testing Log Services > How to Test Log Services
 
 

Support: +1 919.781.1931

support@trianglemicroworks.com

Submit a Support Request Online

Triangle MicroWorks, Inc.

© 2017 Triangle MicroWorks, Inc.All rights reserved.