You are here: Simulate an IED > Simulate an IED from a Discovered Model
Support Home
 

Simulate a Real IED's Discovered Data Model

Tip: Any IED in a 61850 Test Suite Pro workspace can be simulated. IEDs can be loaded from an SCL File or by reading the data model from an IED using discovery.

To simulate an IED based on the configured data model of a real IED:

  1. Create a new workspace and discover the IED data model using the IP address of the IED Important: after you discover the IED data model, you will need to either disconnect 61850 Test Suite Pro or the real IED from the network to avoid conflicts between the real IED and the simulated IED
  2. Go to the IED Simulator tool (see screen shot below):
  3. Click on the IED drop down menu
  4. Select the IED you want to simulate
  5. Click start on the ribbon bar

Click here to learn how to simulate an IED based on an SCL file

Note: It is important that you do not simulate a real IED that is on the same network as 61850 Test Suite Pro. This could cause conflicting GOOSE messages to be published by the simulated IED and real IED or potentially cause other conflicts for IEC 61850 clients that are connected to the real IED.

 

You are here: Simulate an IED > Simulate an IED from a Discovered Model
 
 

Support: +1 919.781.1931

support@trianglemicroworks.com

Submit a Support Request Online

Triangle MicroWorks, Inc.

© 2017 Triangle MicroWorks, Inc.All rights reserved.